想要縮短《Journal of Energy Chemistry》雜志的審稿周期需要作者、編輯部和審稿人等多方面的共同努力，作者可以采取一些有效措施，間接地加快審稿進度，提升稿件的處理效率。

建議如下：

一、提高論文質量

（1）嚴格遵循投稿要求：在投稿前，仔細閱讀《Journal of Energy Chemistry》雜志的投稿指南，包括格式要求、字數限制、參考文獻格式等。確保稿件符合雜志的規范，避免因格式問題被退回修改，從而耽誤時間。

（2）提高論文質量：確保論文的研究內容具有創新性和學術價值，數據準確，論證嚴謹，語言表達清晰流暢。高質量的稿件更容易通過初審，進入同行評審階段。

二、選擇合適的投稿時機

（1）關注期刊審稿周期：在投稿前，了解《Journal of Energy Chemistry》雜志的審稿周期（預計1-3個月）和發表周期（雙月刊），以便合理安排投稿時間。

（2）關注期刊動態：了解期刊的專題征稿或熱點話題，針對性地投稿，可能獲得優先處理。

三、與編輯部保持良好溝通

（1）主動了解審稿進度：如果超過預計的審稿時間仍未收到回復，可以禮貌地向編輯部發送郵件，詢問稿件的審稿進度。

（2）尊重審稿意見：認真對待審稿意見，積極修改論文中的不足之處，共同探討論文的改進方向。

需要注意的是，縮短審稿周期的前提是保證稿件的質量，不能為了追求速度而犧牲學術嚴謹性。

《Journal of Energy Chemistry》雜志創刊于1992年，是由中國科學院主管、中國科學院大連化學物理研究所;中國科學院成都有機化學研究所主辦的學術理論雙月刊。國內刊號CN：21-1585/O4，國際刊號ISSN：2095-4956。該雜志以推動化學改革與發展、探索化學規律為宗旨，致力于為化學工作者、研究者和管理者提供一個學術交流的平臺。

《Journal of Energy Chemistry》雜志投稿建議：

Preparation of manuscripts (Template)

The manuscripts should be printed on good quality A4 paper in a 12 pt Times New Roman font. All manuscripts should include: a title, list of authors, full addresses of authors, an abstract, keywords, all sections of the body of the manuscript, footnotes, and references.

The title should clearly and accurately indicate the contents of the article or communication and should be expressed in adequate scientific terms. No abbreviations should be used in the title.

The full addresses of authors should be placed below the title. 

Footnotes should be included on the first page to give the phone number, fax number, and e-mail address of the author of correspondence, and if applicable, information regarding funding. 

We request that authors should submit abstracts for both articles and communications. Abstracts should state briefly the reason for the work, the significant results, and conclusions.

Keywords should be given at the bottom of the abstract to serve as guidelines for indexing.

The body of the manuscript should be subdivided into the following sequence of the sections: Introduction, Experimental, Results and discussion, Conclusions, and References.

Tables and figures must be numbered consecutively with Arabic numerals and should be self-explanatory. Tables must have a brief descriptive title and include footnotes if necessary.“Figure” should be spelled out instead of being written“Fig.” Figures should have figure captions, either with the figures or collected on a separate sheet. The contents of figures, tables, and word descriptions should not be duplicated.Important instructions concerning Figures and Tables are listed as follows:

Each figure should be located at bottom of the paragraph where it is mentioned first in the text.

Size and font of all words including the X and Y axis, units and legends are 7.5 pt and Times New Roman, respectively. The first letter in the first word is capitalized.

Physical quantity is in italic, and the physical quantity and unit is separated by /not by · or blank, such as T/K，Ea/eV，Z/Ω, mL/min, mL/(h?gcat). When English full name of physical quantity is used, unit should be placed in the parenthesis and there is one blank space between them, such as Potential (V)，Capacity (mAh/g)，Current efficiency (%).

Digit and unit is separated by one blank space. Percentage of weight and volume should be wt% and vol%, not wt.% and vol.%.

Width of figures or images is 8 cm (single column) or 16 cm (double column).

For digital figures, they should be edited in the text. For SEM, TEM, HR-REM images or other photos, their resolution is more than 300dpi

When a figure title contains a few different figures, each figure should be numbered using (a), (b), (c), (d) …… which are inserted in the upper left corner of each figure with closed frame. When a figure contains different lines, these lined should be numbered using (1), (2), (3), (4) …… even though the lines are also differentiated by different colors. 

Table must be three-lined format.

 Photographs should be of sufficiently high quality with respect to detail and contrast. Indicate the magnification by a bar on the photograph.

References should be numbered consecutively in the order in which they are first mentioned in the text. Abbreviations of journal titles should follow the style used in Chemical Abstracts. Reference accuracy is critical and authors are responsible for the accuracy of the references. Only articles that have been published or are in press should be included in the references. Journal articles and books must be cited by the following formats:

Reference to a journal publication:

[1] J. van der Geer, J.A.J. Hanraads, R.A. Lupton, J. Sci. Commun. 163 (2000) 51–59. 

Reference to a book:

[2] W. Strunk Jr., E.B. White, The Elements of Style, third ed., Macmillan, New York, 1979. 

Reference to a chapter in an edited book:

[3] G.R. Mettam, L.B. Adams, in: B.S. Jones, R.Z. Smith (Eds.), Introduction to the Electronic Age, E- Publishing, Inc., New York, 1994, pp. 281–304.

 All manuscripts should include a graphic abstract. Authors are required to provide a single separate A4 sheet containing a small diagram, or other informative illustration (scheme, formula, figure, etc.) that shows the most important aspect of the paper. The diagram or illustration should be a maximum size of 40 mm high×80 mm wide with color. Style and format of the graphical abstract may be found in the example.

聲明：以上內容來源于互聯網公開資料，如有不準確之處，請聯系我們進行修改。